Guru-Z Remote Control
http://guru-z.com/forum/

motor start abruptly
http://guru-z.com/forum/viewtopic.php?f=2&t=8
Page 1 of 1

Author:  vlaporte [ Wed Jan 20, 2010 7:47 am ]
Post subject:  motor start abruptly

I have a HoneyBeeFP and built a Guru Neon frame, added 12mm belt tail kit, added Telebee gyro, added [GE38H]3900kV Brushless motor and [GE118]18A Brushless ESC.
I also use Xtreme fiber blades that are shortened by one inch on each end. It flies great. It was lots of fun gradually adding modifacations.
My only concern is the abrupt start of this brushless motor. I went through the programming and set to soft start but still abrupt. Is this normal for such a small motor?
Thanks,
Vince

Author:  louie_dui [ Fri Jan 22, 2010 2:33 pm ]
Post subject:  Re: motor start abruptly

Hi, what is the programming card you use to program the Guru-Z esc? :?:
I do not used to program the esc with the throttle stick, still not yet find out which programming card to use to program the Guru-Z esc... :(

Author:  vlaporte [ Sat Jan 23, 2010 12:21 am ]
Post subject:  Re: motor start abruptly

Louie,
I do not have a programing card that works - I used the transmitter throttle stick.
Vince

Author:  mystic [ Tue Jan 26, 2010 12:12 pm ]
Post subject:  Re: motor start abruptly

Hi,

You can set the motor to be "very soft start" :D

Author:  vlaporte [ Wed Jan 27, 2010 6:28 am ]
Post subject:  Re: motor start abruptly

I am setting the motor to "very soft start" but still not very soft.
Vince

Author:  mystic [ Sat Jan 30, 2010 12:17 pm ]
Post subject:  Re: motor start abruptly

vlaporte wrote:
I am setting the motor to "very soft start" but still not very soft.
Vince

Hi,
How about the timing of ESC and the curve of TX? :?:
| set mine with Med. timing and the curve not too sharp at first 30% of throttle.

Author:  vlaporte [ Sun Jan 31, 2010 1:06 am ]
Post subject:  Re: motor start abruptly

Program card.
Where can I get a program card for the little GURU (GE series) motor?
I tried my Turnigy card but it does not work.
Thanks,
Vince

Author:  kenlau [ Fri Feb 05, 2010 6:26 pm ]
Post subject:  Re: motor start abruptly

I dont think there is a program card at the moment.
Try the timing option.

Author:  Solitaire [ Sun Feb 21, 2010 3:29 pm ]
Post subject:  Re: motor start abruptly

vlaporte wrote:
Program card.
Where can I get a program card for the little GURU (GE series) motor?
I tried my Turnigy card but it does not work.
Thanks,
Vince


Try a Turnigy Plush ESC and use your programmer with that. The Plush has a "very soft start" option.

Page 1 of 1 All times are UTC + 8 hours
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/